Cortelco 9 Series ITT-9125 Multi-Feature Speaker Telephone

The 9125 dial mode switch is underneath the phone near the battery compartment. If your telephone line supports touch-tone dialing, put the switch in the “T” position.This is the default postion from the factory. If your telephone line requires rotary (Pulse) dialing, put the switch in the “P” position. If you are unsure which system you have, set the switch to the TONE position. Lift the handset. When you get a dial tone, dial a telephone number. If the dial tone continues, move the switch to PULSE, and then dial the telephone number again.The 9125 ships configured for wall mounting. No changes are necessry. Connect the power adapter.

The power adapter connects to the jack marked DC 9V on the back of the phone. Plug the large part of the adapter into the wall outlet. Use only a 9V DC. 300mA, center positive Class 2 adapter. The adapter is necessary for LCD backlighting. Connect the line cord. The line cord connects to the jack marked Tel. Line on the back of the phone. Mount the phone on the wall jack. Plug the coiled cord into the handset, and then plug the other end of the cord into the handset jack. Place the handset on the base

• Mute
• Hold
• 20 Speed Dial Locations (two touch)
• Flash
• Redial
• Speakerphone
• 2.5mm Headset Jack
• Adjustable Stand
• Desk/Wall Mountable
• Hearing Aid Compatible
• One Touch Call Forward
• Call Waiting Off Button
• End Call Button
• Conference
• Hold (PBX)
• Clear Message Button
• Speaker Volume Control
• Handset Volume Control
• Ringer Low/High/Off